Snapper Front Implement Lift Kit 1691195 Manuel d'utilisateur télécharger pdf

INSTALLATION

FRONT IMPLEMENT Lb?- KIT

INSTRUCTIONS

MFG. NO. 1691195

WARNING

Stop the engine and remove key before

installing kit or making any adjustments.

NOTE: For tractor Mfg. No. 1691017 with serial num-

ber 1273 or lower, and tractor Mfg. No. 1601019 with

serial number 10400 and lower, it will be necessary to

replace the existing bracket support with part number

1676455 in order to install this kit.

NOTE: Make sure a// hydraulic wnnections are tight.

Where possible make connections using a vise before

installing parts on tractor.

Check kit parts against illustration and parts list on

pages 2

2. Remove tractor hood to ease installation.

3.. See Figure 3. Remove the existing retaining rings.

Install the bushing (4) and lever (3). Install the curved

washers and retaining rings.

4. Disconnect hoses from existing valve. Note and mark

their positions. Remove the valve by removing nut

and bolt that holds the hydro fill tube.

5. Install the new valve using existing hardware and

new

i/4-20

x 2 capscrew (28, figure 3). This longer

capscrew also secures hydro fill tube clamp. Use the

upper hole in the mounting plate for the new cap-

screw as shown.

6. See figure 1. Connect the hoses to the new valve in

the same positions as on original valve. Connect the

right and left tubes (5

& 6, figure 3) as shown.

7, Route the front tubes (9

10, figure 3) under the

front brackets as shown in figure 2.

6. See figure 4. Assemble the plastic plugs

(19)

retain-

ing rings

(17)

bodies (14) and brackets (15

16).

Attach to tractor as shown in figure 3.

On right-hand side, secure bracket (16, figure 3)

using capscrew

(16)

lockwasher (20) and nut (21).

On left-hand side, secure bracket (15) using same

hardware used to secure bracket for PTO idler

spring.

The PTO spring is under tension when

Installed.

Figure 1.

A. Lift Lever Support E. Hose

E-Ring F. Elbow

C. Tube, Right (Ref. E, Fig.1)

D. Tube, Left, (Ref.

Fig. 1)

Figure 2. (Hood Removed)

A. Brackets

Figure 3.

A. Plugs 8. Brackets

FORM

1701802

1 2 3

Résumé du contenu

Page 1 - INSTRUCTIONS

INSTALLATIONFRONT IMPLEMENT Lb?- KITINSTRUCTIONSMFG. NO. 1691195AWARNINGStop the engine and remove key beforeinstalling kit or making any adjustments

Page 2 - Form 1701802

10. See figure 3Connect the left and right tubes (5 &6) to the front tubes (9, IO) using the tees (7).11. Underneath tractor, notice that the fro

Page 3

Curvedwasher. \-‘\‘\‘\‘l-NOTE: Use standard hardwaretorque spec. chart unlessotherwise noted.,’we 4. Front Implement Lift KitFORM - 17018023PRINTED IN

Commentaires sur ces manuels

Pas de commentaire

Snapper Front Implement Lift Kit 1691195 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Snapper Front Implement Lift Kit 1691195. Snapper Front Implement Lift Kit 1691195 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Snapper Front Implement Lift Kit 1691195